#Anylogic sales process tutorial how to#
#Anylogic sales process tutorial full#

The speed of the warmed-up flow is limited by the block with the lowest rate. If the front blocks do not have space, a conveyor will freeze, unlike the accumulating conveyor of the Process Modeling Library. Conveyors do not have capacity, they just move a certain amount of material at the specified speed. In a fluid flowchart, it is determined by the space in tanks and pipelines. This feature is very similar to the pull protocol of the Process Modeling Library: the flow moves until there is a block that pulls agents and space for these agents. In the model, it does not limit throughput, so the flow moves at conveyor speed. Otherwise, the flow is forwarded to the bottom branch.Ī Split block may limit the throughput. In the model, a Split block forwards the flow to the top branch if the Mix tank has space. This block acts like a rudder, routing materials to the top or bottom branch, as well as splitting the flow among both branches in a certain proportion. The first two branches accumulate a certain buffer in Regular tanks and then transport materials to the first Mix tank.

Going back to the model, there are three Source blocks that create a material flow, according to the rate. If, for example, the Tank is empty, the following Pipeline will not transport the materials that remain inside it after the Tank becomes empty. It has capacity and rate (throughput), but it does not push its contents, it just transports materials in case the behind blocks push the flow.

#Anylogic sales process tutorial full#

On full capacity, Tank becomes a bottleneck because both rates become equal. Otherwise, Tank will accumulate the materials at the incoming rate. If the incoming rate is not greater than outcoming, then Tank will be empty. Tank pushes its materials like Source block, but unlike Source, its capacity is limited. Tank acts like a bath because it has capacity and an output valve. Its ouput port becomes orange, indicating that the rate is equal to 0. If the front block cannot accept the flow (has a rate equal to 0, or a full Tank with a closed output valve), then Source block stops generating the flow. Source block creates a flow, at a certain rate, and pushes it. Finally, each 0.5 kilogram of prepared mass forms a chocolate bar, an agent of the Process Modeling Library.Īlmost every model has three basic blocks: Source, Pipeline, and Tank.

Transportation is performed with pipelines and conveyors.

#Anylogic sales process tutorial how to#

Also, it shows how to design a branch fluid flowchart with Split, Merge, Select Input, and Select Output blocks. Mainly, the model illustrates how to use different tanks, including Regular tank, Mix tank, and Process tank.

Welcome to Part 2 of the Fluid Library orientation, which showcases an example model of chocolate production.